Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cleaning & Sweep Across Quincy
A chimney sweep in Quincy, MA typically costs between $189 and $325 for a standard single-flue cleaning, while a two- or three-flue triple-decker runs $350 to $550 depending on creosote load and access. Most Quincy homes we clean fall into the older multi-family category, which means we’re quoting based on what the camera shows us, not a flat guess. We know the housing stock here: the pre-war brick three-deckers in Quincy Point, the capes in Wollaston, the ranches in West Quincy. Each one ages differently, especially within a mile of the water. Call (857) 567-8887 and we’ll give you a written price before anyone sets foot on a roof.

Key Takeaways:
- Standard single-flue sweep in Quincy: $189-$325. Multi-flue triple-decker: $350-$550.
- Salt air off Quincy Bay corrodes caps and flashing faster here than in Milton or Braintree. Stainless steel is the only component we’ll install within a mile of the water.
- Every visit includes a camera-scan inspection and a documented photo record. You see what we see before you spend a dollar on repairs.
- Landlord or tenant? We’ll tell you which flue serves which unit and write the report so responsibility is clear.
Why Level Two Chimney Boston Is Quincy’s Preferred Chimney Cleaning & Sweep Company
Quincy homeowners call us because we document what we find, then put the price in writing before the work starts. That’s not a marketing line. It’s Clause 1 of the Haven Standard, and it’s how we’ve operated since 2009 across more than 38,000 inspections and cleanings. When our technicians arrive at a triple-decker on Hancock Street or a cape off Furnace Brook Parkway, they’re background-checked, uniformed, and assigned by name before the appointment. You get a text when they’re on the way.
Response time to Quincy is usually one to three business days for a standard sweep, depending on the season. October through December fills up first, so if you’re reading this in September, book before the first cold snap. We coordinate dispatch from our Boston office, but the crews who show up in Quincy know the local building stock. They’ve swept chimneys in Wollaston that hadn’t been touched since the last oil-to-gas conversion. They’ve repointed crowns in Quincy Point where the mortar had turned to sand from years of salt spray. That’s not something a generic chimney company picks up on a first visit.
Corrine Halstead, our owner, set the expectation years ago: written scope, written price, written warranty, camera evidence. Nothing gets recommended without a photo to back it up. Quincy’s older chimneys deserve that standard, because too many homeowners here have been told they need expensive repairs without ever seeing the inside of their own flue.
Our Chimney Cleaning & Sweep Services in Quincy

Every Chimney Cleaning & Sweep visit in Quincy starts the same way: with a camera. You can’t clean what you haven’t looked at, and on a three-flue chimney in Quincy Point, looking means sending the camera down each flue separately. Here’s what we handle most in this city.
Level 1 Inspection
A Level 1 inspection is the basic check we run when a chimney’s been cleaned recently and nothing about the system has changed. In Quincy, we see a lot of Level 1 calls on single-family capes in West Quincy where the furnace flue gets used all winter and the fireplace flue sits dormant for years. The inspection covers the accessible portions of the flue, the firebox, the damper, and the visible exterior. If you haven’t changed fuels or appliances, this is usually enough. If you just bought the house, it’s not.

Level 2 Inspection
Level 2 is the camera-scan inspection, and it’s what we recommend for any Quincy home that’s changing hands, converting from oil to gas, or hasn’t been inspected in five or more years. The camera goes down every flue in the chimney, not just the one that looks active. On a triple-decker, that means three separate scans. We find abandoned flues with uncapped tops, cracked clay tiles, and mortar joints that have been eaten away by marine air. You see every frame. Clause 4 of the Haven Standard requires a photo record on every job, and we’ve been doing that since 2009, years before insurers started asking for it.

Creosote Removal
Creosote removal in Quincy isn’t always a straightforward brushing. First-degree creosote, the dusty brown soot you’ll find in a regularly swept fireplace flue, comes out with a standard brush. Second-degree, the flaky black stuff that builds up in a firebox that’s been ignored for two or three seasons, takes rotary cleaning. Third-degree, which we see in rental triple-deckers where no one was ever sure who was responsible for the chimney, is a hardened tar glaze. Brushing alone won’t touch it. HeatShield’s ceramic resurfacing system is the fix we most often recommend at that point, because it restores the flue surface instead of just scraping it. For other fireplace needs, see our Fireplace Services in Quincy.

Soot Removal
Soot removal is what oil and gas flues need, and in Quincy that usually means cleaning the furnace flue in a basement that hasn’t been touched since the last tenant moved out. Soot is acidic. Left in place, it holds moisture against the flue lining and accelerates deterioration, especially on the harbor-facing side of a building where the brick is already fighting salt air. We sweep the flue, vacuum the base, and show you the before-and-after photos on the spot.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterTrusted Brands We Service in Quincy
We work with the materials that hold up in this climate. For Quincy chimneys near the bay, that means stainless steel caps and flashing, never galvanized. Galvanized steel corrodes in salt air within three to five years. Stainless lasts decades. We stock flue liners from HeatShield, caps from Olympia Chimney, and chimney components from Famco specifically because our Quincy customers need parts that survive marine exposure. We also provide Duraflex service in Quincy for homeowners who need reliable liner solutions in this climate. If your chimney needs a new cap, crown repair, or liner work, we’re not waiting three weeks on a special order. Most of what we need comes from our Boston warehouse, matched to the specific flue size we measured with the camera.
Common Chimney Cleaning & Sweep Problems We See in Quincy Homes

- Abandoned uncapped flues on multi-family chimneys. When a unit in an older Quincy building converts from oil to gas, the old oil flue often gets abandoned in place. If it’s not capped with stainless steel, it lets rain and salt air inside, which corrodes the interior masonry and can push moisture into the flue next door that’s still in use.
- Galvanized caps and flashing failing early near the water. We replace galvanized components on Quincy Bay-facing chimneys constantly. The salt in the air chews through the zinc coating fast. Stainless is the only material we’ll spec within a mile of the coast.
- Third-degree creosote in rental triple-deckers. When landlord-tenant disputes leave a fireplace flue uncleaned for a decade, creosote hardens into a tar glaze that a standard brush can’t remove. We see it in Quincy Point and South Quincy more than almost anywhere else in our service area.
- Mortar joints spalling from salt attack. The lime-based mortar in pre-war brick chimneys absorbs airborne salt, especially on the harbor-facing side. It turns powdery and fails from the outside in. Repointing a crown on a Quincy waterfront home is a regular job for us, and usually needs doing years before the same repair in Milton or Braintree.
Pricing for Chimney Cleaning & Sweep in Quincy, MA
Here’s what we charge in Quincy, and we put it in writing before we start. A standard single-flue sweep runs $189 to $325. A two-flue chimney, common in a two-family in South Quincy, runs $310 to $450. A three-flue triple-decker runs $350 to $550, depending on creosote classification and roof access. If the camera finds a cracked flue tile or a failing crown, you’ll get a written repair quote with photos attached. You won’t get a recommendation you can’t verify. Every quote includes the inspection, the photo record, and a written warranty under the Haven Standard’s 365-Day Done Right Promise. Bring us a competitor’s written estimate and we’ll give you a free second opinion on it. Call (857) 567-8887 for an exact quote. Estimates are free, and there’s no charge for the camera scan when it’s part of a sweep.
We Also Serve Cities Near Quincy

Our crews cover the South Shore and the metro area around Quincy, so if you’re just over the border in Chimney Cleaning & Sweep territory in Milton, Boston, Cambridge, or Norwood, the same written-price standard applies. The coastal exposure matters differently in each town, and we spec components accordingly.
Serving Quincy, MA - Our Local Coverage Area
We’re based in the Quincy area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Chimney Cleaning & Sweep in Quincy

Every flue should be swept at least once a year, regardless of fuel type. On a Quincy triple-decker with one unit on gas, one on oil, and one using a fireplace, that means three separate flues serviced on the same visit. The gas flue may look clean, but the camera catches things a visual check misses. We recommend an annual sweep for all three, with a Level 2 camera inspection every two years or after any fuel conversion. Call (857) 567-8887 and we’ll schedule the full stack.
Salt air. Quincy Point and the eastern-facing neighborhoods sit directly on Quincy Bay and Boston Harbor. The airborne salt attacks lime-based mortar, breaking down the bonds that hold brick and crown together. Milton, just a few miles inland, gets none of that exposure. We see crowns in Quincy Point that need repointing ten to fifteen years before identical chimneys in Milton. If you’re within a mile of the water, stainless flashing and caps are the only materials that hold up. We’ll show you the difference in salt corrosion levels on your own photos.
It means a flue that used to vent an oil furnace was left open to the sky when the unit converted to gas. The open top lets rain, snow, and salt-laden air into the chimney structure. That moisture eats interior mortar, causes spalling on the brick exterior, and can migrate into the active flue next to it. It also lets animals nest. The fix is straightforward: install a stainless steel cap over the abandoned flue and verify the active flue is still sound. We do this on Quincy triple-deckers all the time. Call (857) 567-8887 for an exact quote.
Yes, first-degree creosote is the dusty brown soot that brushes out with standard equipment. But left alone in a Quincy rental where no one takes responsibility for the chimney, it doesn’t stay first-degree. Two or three seasons of use build it into second-degree, then third-degree, which is a hardened tar glaze that requires chemical or ceramic treatment, not just brushing. Annual sweeping is cheap insurance. A landlord who skips it is looking at a much bigger bill later, and a tenant who ignores it is living with a fire hazard that was entirely preventable. We write our reports so responsibility is clear. Call (857) 567-8887 for a written price.
Yes, and it’s measurable. Galvanized caps on a Quincy Bay-facing chimney corrode through in three to five years. Stainless steel lasts thirty or more. The salt spray off the water is relentless, and it concentrates on whatever’s highest and most exposed. We pulled a galvanized cap off a Quincy Point home last month that was rusted through so thoroughly it crumbled in our hand. The stainless replacement we installed will outlast the roof. We spec stainless for every coastal Quincy chimney, and if your current cap is galvanized, we’ll show you the corrosion in the photo record before we touch it. Call (857) 567-8887 and we’ll inspect yours.
We swept a triple-decker in Quincy Point not long ago where the shared chimney had three flues: one active for a gas furnace, two abandoned after oil-to-gas conversions. The uncapped abandoned flues had let salt-laden moisture eat away at the interior mortar, causing spalling on the brick exterior and pushing water into the active flue. We installed stainless caps on the abandoned flues, swept the active one to remove first-degree creosote, and recommended repointing the crown before the next nor’easter. You’d never know any of that from the ground looking up. The camera showed us in five minutes.
Ready to book? Call (857) 567-8887 for a free estimate. We’ll give you a written price before we start, document everything we find, and leave you with a photo record of exactly what was done.
Written by Corrine Halstead, Owner at Level Two Chimney Boston, serving Quincy and the surrounding South Shore since 2009.





Before
After
Before
After